Simcenter Blog Volupe

Splitting faces in Simcenter STAR-CCM+ 3D-CAD module

17 February 2023

Home In this week’s blog post we will demonstrate the different options you have to split faces inside the 3D-CAD […]

10 February 2023

Home In projects where simulations are performed there is often a need to investigate changes in results due to changes

3 February 2023

Home One of our goals as design engineers is to get close as we can to reality when doing simulations

27 January 2023

Home In this week´s Volupe blog post it is time to look at the gap closure tool in the surface

20 January 2023

Home Due to the extensive multiphysics capabilities in Simcenter STAR-CCM+, setting up simulations may sometimes involve a lot of scrolling

13 January 2023

Home In this week’s Volupe blog post we will take look at the combination of overset mesh and adaptive mesh

5 January 2023

Home In this week’s blog post we will look at the remaining expert features from the blog post – Thin

30 December 2022

Home In this week’s blog post we will look at the connection between Simcenter STAR-CCM+ and your CAD software. We

23 December 2022

Home We at Volupe have seen an increase lately on the wish for simplifying wire grid geometries (e.g. fishing nets,

16 December 2022

Home In this week’s blog post we will go over the possibilities of simulating particulate flows in Simcenter STAR-CCM+, within