Star-CCM+ Job Scheduler

12 June 2020

I have a passion for optimization! And I enjoy automating tasks. Consequently, I really admire the Design Manager in

Finding the center of a circle in Simcenter STAR-CCM+

3 June 2020

Simcenter STAR-CCM+ I have always had a hard time finding the coordinate for a circle center in Simcenter STAR-CCM+.

28 May 2020

Last summer I oversaw the creation of a two-day introduction course in Simcenter STAR-CCM+. The course was held at

20 May 2020

Have you met Templates? Robin showed you in last week’s blog, how easily you can build you template simulation

15 May 2020

Filters and queries in STAR-CCM+ In this article I will go over filters and queries. Filters and queries can

8 May 2020

In this short video I will go over the use of the tool screenplay in Simcenter STAR-CCM+. In screenplay

24 April 2020

Advanced rendering in Simcenter Star-CCM+ In this post I will go through some advanced post-processing. The aim is to

17 April 2020

Did you know that the STAR-NX CAD client allows to configure a bi-directional link between Simcenter STAR-CCM+ and NX?

8 April 2020

In this post I will give a few examples on how we can find zones in our geometry, in Simcenter

3 April 2020

So, winter is over, and we are heading towards spring here in Sweden! Unfortunately, the presence of snow down here